• Stainless steel frame construction
  • Belt widths > 24 inches
  • Loader reach radii > 27 feet
  • Vertical position control for the loading arm
  • Hinged belt access doors
  • Belt cleaners & scrapers
  • Belt speed and/or tracking sensors
  • Abrasion-resistant infeed and discharge transitions
  • Post, haunch or platform mounting
  • Special control functions, interfaces and enclosures
  • Retractable loading spouts with 2 to 20 feet of vertical travel

DYNATEK’s Belt-based EconoLoader™ is the most versatile and economical articulated loader available. A variety of design configurations involving troughing idlers, corrugated sidewall belts and even air-guided belt conveying, make this version of EconoLoader™ the right choice for a broad range of granular, irregular, abrasive or sticky materials like coal, sand, gravel, minerals and fertilizer.

Belt-based EconoLoaders™ consist of (2) conveying arms, each containing its own belt conveyor. Material enters the loader through an inlet in arm 1 and discharges through the outlet or a dust recovery load-out spout at the end of arm 2 (loading arm). A reach radius of up to 30 feet and roughly 330 degrees of rotation enable the discharge point to be positioned quickly and precisely over each loading point or hatch in the transport vehicle. Once in position, sequenced conveyor start-up insures smooth, plug free loading at rates up to 15,000 cubic feet per hour.

Construction: 1st and 2nd conveying arms = carbon Steel, structural box or truss frames
Belts: 16 – 24 inch wide, 2 and 3-ply
Drive: totally enclosed, lagged drum motors
Loader Reach: 22 feet from inlet CL to discharge CL typical for truck loading; 27 feet from inlet CL to discharge CL typical for railcar loading
Loading Rate: Up to 26,000 cubic feet / hour (material dependent)
Loader Positioning: Hydraulic or electromechanically driven slew bearings enable each arm to rotate up to 330 degrees horizontally at 180 degrees per minute.
Finish: White metal sandblast; Devoe™ Bar-Rust 235™ primer coat; Devoe™ Devthane™ 379UVA Urethane Gloss Enamel finish coat
Control: Fully wired, NEMA 4 control panel with main disconnect, palm button-type emergency stop and wireless, handheld push-button pendant allows operator to rotate arm 1 and 2, raise and lower a load spout, start / stop conveyor operation and start / stop material supply

Ask Us About

Optional Features

Special Conveyor Designs
Custom Control Panels
Installation & Commissioning Assistance
Wear-Resistant In-Feed and Discharge Chutes

Ask About DYNATEK System Options